Difference between revisions of "CGNATs and IPv6 over Mobile Broadband"
(→IPv6) |
|||
| Line 14: | Line 14: | ||
Then go here: | Then go here: | ||
| + | |||
https://whatismyipaddress.com/ | https://whatismyipaddress.com/ | ||
| + | |||
| + | '''Write your address on the board under the heading Wired LAN''' | ||
Does it correctly resolve your location and IP? | Does it correctly resolve your location and IP? | ||
Revision as of 11:49, 20 July 2023
In this lab, we will explore the default behaviour of Mobile broadband with an emphasis on addressing. Before we start looking at the addressing or performance of these networks, lets start with a baseline. Start with the Ubuntu Virtual Machine in the labs.
Contents
Basic Network Baselining
Wired LAN
Open a terminal an type:
ip a
What is your IP address? Is it IPv4, or IPv6? Is it private/public? Confirm your IPv6 predictions here:
https://ipv6test.google.com/
Then go here:
https://whatismyipaddress.com/
Write your address on the board under the heading Wired LAN
Does it correctly resolve your location and IP?
Run a speed test at: linux
https://www.speedtest.net/
What is your upload and download speed? What latency is reported?
Try pinging:
8.8.8.8
And then:
2001:4860:4860::8888
This is Google DNS server, they are the IPv4 and IPv6 addresses of the same server. Only ping for less than 20 seconds to prevent the university from being blacklisted. What latency do you get? Does it vary a lot?
What is your DNS server? Try a:
cat /etc/resolv.conf
Reflect on the results and compare them with your lab partner.
Eduroam
Start by clicking in the top right in Ubuntu and disabling both ethernet Adaptors. Connect to eduroam through your Wifi adaptor in Linux, then repeat all of the tests above. Is there any difference? Reflect on the results and compare them with your lab partner.
Open a terminal an type:
ip a
What is your IP address? Is it IPv4, or IPv6? Is it private/public? Confirm your IPv6 predictions here:
https://ipv6test.google.com/
Then go here:
https://whatismyipaddress.com/
Does it correctly resolve your location and IP?
Run a speed test at:
https://www.speedtest.net/
What is your upload and download speed? What latency is reported?
Try pinging:
8.8.8.8
And then:
2001:4860:4860::8888
This is the Google DNS server, they are the IPv4 and IPv6 addresses of the same server. Only ping for less than 20 seconds to prevent the university from being blacklisted. What latency do you get? Does it vary a lot?
What is your DNS server? Try a:
cat /etc/resolv.conf
Reflect on the results and compare them with your lab partner.
Mobile Broadband
Lets start by starting up your personal hotspot on your mobile phone. This should be easy on iOS or Android. Please make sure you use a password. Repeat the steps above.
Open a terminal and type:
ip a
What is your IP address? Is it IPv4, or IPv6? Is it private/public? Confirm your IPv6 predictions here:
https://ipv6test.google.com/
Then go here:
https://whatismyipaddress.com/
Does it correctly resolve your location and IP?
Run a speed test at:
https://www.speedtest.net/
What is your upload and download speed? What latency is reported?
Try pinging:
8.8.8.8
And then:
2001:4860:4860::8888
This is Google DNS server; they are the IPv4 and IPv6 addresses of the same server. Only ping for less than 20 seconds to prevent the university from being blacklisted. What latency do you get? Does it vary a lot?
What is your DNS server? Try a:
cat /etc/resolv.conf
Reflect on the results and compare them with your lab partner.
IPv6
While still connected to your phone's mobile broadband connection, open a terminal and type:
sudo wireshark
Capture on your WiFi interface do some casual browsing as you capture traffic. Are you using IPv4, IPv6 or both? How do you think your phone works it out.
IPv4/IPv6 Dual Stack
Right now, you should have an IPv4 and an IPv6 address similar to this diagram to the right. Use wireshark to capture this IPv4 and IPv6 traffic.
Fine one of each of the following 3 messages, read about each one and spend 2 minutes on each digging through the headers in wirshark to work out what is going on.
- Neighbor Solicitation
- Neighbor Advertisement
- Router Advertisement
Look closely at your IPv6 addresses. There should be two that are similar. What is the difference? Do your research on this. Use wireshark to work out which address is the source address in your outgoing communications.
Link Local Addresses
You may be familiar with the idea of a MAC address being a link local address that is only relevant on the LAN. The analogy is not quite correct as MAC addresses work at the data link layer. The closest relative to IPv6 link-local addresses ais the 169.254.0.0/16 subnet. You often see this assigned when you boot up a computer and there is an active network interface but no DHCP server can be found. In IPv6, these link local addresses are always present and are assigned from the block fe80::/10.
Have a look at your link-local address with an:
ip a
Can you identify yours? Now I want you to try to identify the link-local address of your phone and ping it. To do this, look at the neighbor solicitation and neighbour advertisement messages.
You may find that your dns server is your smarthphone.
Loopbacks
By now you should know that 127.0.0.1 is a special address reserved for self testing nad address is typically used by applications or services that need to communicate with themselves locally. Examples include such as testing client-server interactions or running network services on the same machine they are being accessed from.
Try :
ping 127.0.0.1
Now try:
ping ::1
IPv6 Only
In this final section, we will look at the state of the internet through the lens of an IPv6 only connection. Delete your IPv4 address on your Linux box with:
sudo ip addr del 172.20.10.2/28 dev wlx00c0ca967d99 (Not you IP and dev name will differ)
Now browse the internet and explore what works and what breaks. Capture in Wireshark and have a close look.
Security
One of the promises of IPv6, is the elimination of NATs. This solves a number of networking headaches, but does it really mean that your machine is now directly connected to the Internet, without any of the firewall like protections of NAT.
Start by installing nmap
sudo apt intstall nmap
Then install apache2
sudo apt install apache2
Port scan yourself
nmap ::1
Now trade IPv6 addresess with a friend. Port scan each others IPv6 addresses over the Internet. What did you find? What is going on?
